How to install Mangoose JLR SDD V145

Mongoose JLR V145 is tested working fine on Jaguar and Land Rover. Here is the Mongoose JLR V145 installation instruction.

SDD V145 compatible hardware:

1.JLR Mangoose interface Cable, $39.99+free shipping

2.JLR Mangoose SDD Pro, $52+free shipping

3. JLR Mangoose SDD Pro support JLR till2014, $40.99+free shipping

4. Mangoose 3 IN 1 support JLR Toyota Volvo, $47.99+free shipping

5.VXDIAG VCX NANO for Jaguar and Land Rover 2 in 1, $99+free shipping

System Requirement:

WIN7 32 Bit

Processor over I3 and I5

Internal memory over 1G

Hard Disk:over 200G

Installation instruction:

You should make sure the network connection is active before installing the software.

Open the CD and copy these files to the desktop

Step1: setup SDD_145.00_FULL

Then open [SDD_145.00_FULL]

Choose language and click [NEXT]

Preparing setup, waiting…

Click NEXT

Choose [I accept…] and click next

Choose [I have read and understand…] and click next

Click OK

Click install and wait until installation complete

It will pop out the message, click no

Install driver, click NEXT

Then click Finish to exit driver setup wizard

And it may take you about 50minutes to 3 hours for the installation.

Then click finish to complete setup

Step2: setup VDF_JA_145

Open the CD and open VDF_JA_145

Choose language and click [NEXT]

Waiting…

Then click Finish to exit the wizard

Step3: setup SPA_145

Open [SPA_145]

Installation complete, click Finish to exit the wizard

Step4: setup VDF_LA_145

Open [VDF_LA_145]

Choose language and click [NEXT]

Waiting…

Then click Finish to exit the wizard

Step5: setup VDF_JV_145

Open [VDF_JV_145]

Choose language and click [NEXT]

Waiting…

Then click Finish to exit the wizard

Step6: setup VDF_LV_145

Open [VDF_JV_145]

Choose language and click [NEXT]

Waiting…

Then click Finish to exit the wizard

Step7:

Then disable both wireless net connection and local area connection

Open [JLR Driver] file and open [MangoosePro_JLR] to begin install.

Step8:

Extract [JLR AutoInstall Patch 145] to the desktop

Open the file -> [Autoinstall]-> [AutoJLR]

Click patch and it will build a new file on the desktop called [user&pass]

Open the [user&pass] file to get username and password

Then open [JLR SDD] on the desktop

And input userID and password you have gotten from the [user&pass] file and click identify

User authentication successful, click continue

Dealer information

Connect vehicle with laptop via USB cable

Input VIN and click identify vehicle

Done!

Article from OBD2 Blog